![]() ![]() However, it’s not as difficult as it sounds if you have an intermediate amount of plumbing aptitude or experience. Final Thoughtsįor beginners, this type of fitting might not be up your alley. One should remain still, to stabilize the pipe, while the other does the tightening. Step 3: It’s important that you use two wrenches when tightening down the union. If the end has split, cut off the flared portion and repeat the process.Inspect your work carefully after removing the tubing from the block.As you turn the handle, the cone flares the tubing’s end.Alighn the compression cone on the tubing’s end and tigthen the screw. ![]() Choose the hole in the flaring block that matches the outside diameter of the flexible copper pipe.Sliup the flare nut on before you flare the end of the tubing.If not, expect it to take longer as you learn how to use the tool. It will take you about 30 minutes to join 3 pieces together in a union if you have some flaring tool experience. To get started, you’ll need a flaring tool and 2 adjustable wrenches. Sometimes, the tubing splits while being flared, so, if possible, make the flared connection first, then cut the tubing to length. This 2-piece tool reshapes the end of the copper pipe, “flaring” it to fit into a special flare fitting. And unlike compression fittings, a flare fitting requires a flaring tool. Keep in mind, you can only use flare fittings with flexible copper tubing, not on a rigid copper pipe. Notice the flared end of the soft copper tubing? The flare is what you’ll create with a flaring tool. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |